Safariland's New Holster Tackles Suppressed Carry's Heat and Fit Problems
Safariland has released the 6TS RDSQ, a dedicated retention holster for Glock 19 and Glock 45 pistols running a red-dot optic, weapon light and suppressor together, a configuration most duty holsters can't handle.
Snapshot
GarandThumb's review, based on Safariland's published specs and preproduction evaluation rather than independent field testing, calls the RDSQ the most credible factory suppressor holster yet for Glock 19/45 owners. The piece stresses that buyers must verify their exact pistol, light, optic and suppressor combination before buying, and flags suppressor heat as the biggest practical concern.
Key points
- Retention design: The RDSQ uses an SLS rotating hood instead of Safariland's usual ALS lever, because the looser tolerances needed for a suppressor made consistent ALS locking unreliable.
- Fit and compatibility: Initial models (6004RDSQ at roughly $252.50, 6005RDSQ at roughly $262.50) center on Glock 19 and Glock 45 with supported SureFire, Streamlight or Nightstick lights and optics from Trijicon, Aimpoint, Holosun, Leupold, SIG and Vortex; clone pistols aren't guaranteed to fit.
- Draw changes: Safariland's own evaluator recorded draws around 1.5 seconds versus 1.2–1.3 seconds from a Level III holster, reflecting the longer vertical draw a suppressor requires.
- Heat warning: Safariland reported suppressor temperatures exceeding 400 degrees under rapid fire and advises letting the can cool before reholstering rather than reholstering immediately.
- Limitations: Right-handed-only launch configurations, required full-size lights, and added mounting hardware can push total cost well past the base price.
Quick take
For permit holders exploring suppressed carry, a niche that's growing as suppressor ownership becomes more accessible, GarandThumb's review is a useful reminder that fit, draw mechanics and heat management matter more than the marketing photo. It's not a concealment holster, and the site is clear that buyers should confirm every component before assuming it works with their setup.
Read the full story: garandthumb.com